CONSTRUCTION
An industrial gas-fired furnace is usually of steel construction, the inner and outer shells made of steel plates, comprises of 4 separate "thick, 6 lb/ft3 density mineral wool insulation are. The plates constructed to minimize metal-metal contact between the inner and outer shells and reduce heat flow from the furnace chamber to the outer surface. The structures are self-supporting, rigid, and support of adequate strength for all the auxiliary facilities. Interior Surfacescan be made of aluminized 16 or 18 gauge steel and outer surfaces are made with 16 or 18 gauge aluminized steel as well.
OVEN BURNER & HEATING
The furnace is gas fired by one or more fired burner. The burners are located generally in the combustion chamber, separated from the working chamber. Typical burners are 1.0 x 106 BTUH in a way that the furnace can be reached the appropriate temperature in sufficient time to construct it. Electric heaters are used, are located at theWalls of the entry and exit ends of the oven. Circulating in the oven is heated by gas fired burners in the combustion chambers and the electric heaters on the walls. The design of the combustion chamber is the specification for gas-fired heating system to satisfy.
Recirculation system
An oven at about 25,000 CFM capacity would be made available for example with a (1) Air Kit Type circulating blower with. The circulating blower with belt guard, belt completelyDrive, air flow switch to Plummer and buttons. The recirculation fans are driven by a 5 - 50HP engine mounted on an adjustable base.
EXHAUST
The furnace is equipped with one or more multi-purpose fan with 1,500 CFM capacity each (on average). The hood is equipped with belt guard, belt drive, changing airflow, Plummer completed and keys. The hood is driven by a motor mounted on an adjustable base.
Forward and reversePlenary
Advantages and return plenum, should contain jets, will be of 18 gauge aluminized steel, made adjustable to the river equilibrium. The hot air in the ovens of the supply plenum on the floor and is delivered back through the upper opening into the combustion chamber.
Electrical controls
A large NEMA-12 control panel is usually used to control the house. The panel can be attached to the furnace side wall. A controller, switches, and specifyingLights on the face of the control panel mounted. In addition, the furnace has the following controls built into the system:
o Control Power switch.
o High-temperature limit, to ensure high security.
o Temperature Controller for controlling the burner.
o the heater fan is integrated as a heat source and the burner for complete combustion of the fuel gas.
o Fan Interlock: All fans of air flow switch interlocked to avoid overheatingthe oven if either fan is turned off or out of service.
o Power
ไม่มีความคิดเห็น:
แสดงความคิดเห็น