Attention plasma cutter! General Welding Safety is not enough.
There are a few things about plasma cutting safety, general safety tips from the various welding processes
This short list of plasma cutter safety tips geared to light duty plasma cutting using compressed air no major industries that use gas mixtures and water cutting tables.
Electric Shock Can Kill
- The operation of a plasma cutter completes a circuit between the torch and workpiece.The workpiece and the workpiece touch All are part of the circuit.
- Never touch the torch body, the workpiece or the water in a water table, if the plasma system in operation.
Voltage and current
- Plasma Cutter output voltages are much larger than welding voltage, usually 100-200 volts.
Precautionary Measures
- Never remove the workpiece, including the waste cutoff, while you cut. Let the workpiece on the workbench with the workCable is connected during the cutting.
- During plasma arc cutting operations do not move the work clamp.
Wear insulated gloves and boots dry, and keep your body and clothing.
- Do not stand, sit or lie, or otherwise touch any wet surface when using the plasma cutter system.
- Insulate yourself from work and ground using dry insulating mats or covers big enough to prevent any physical contact with the work or ground. If you need in or near a wet area to work, veryCaution.
Work Cable
- Ensure the metal-metal contact between work cable and work piece or work table.
- Work cable clamp should avoid contact with clean metal free of rust, dirt, painted surfaces, etc., make
- Do not attach a cable to the work piece, which fall away when the cut is completed
Plasma Cutter ARC RAYS
Plasma arc cutter to produce intense beams visible and invisible (ultraviolet and infrared) rays that can burn skin and eyes.
Protective Clothing
--Guantlet gloves, safety shoes and hat.
- Include flame-retardant clothing, all the vulnerable areas.
- Cuffless trousers to avoid entry of sparks and slag.
- Remove fuel such as butane lighter or matches from their pockets before cutting.
Noise levels of plasma cutting
- Plasma cutting systems can cut noise levels above 120 dB produce at high amperage.
- To use hearing protection when operating or working nearPlasma cutting operations.
Toxic fumes and gases
Generate plasma cutting can cause toxic fumes and gases, which deplete oxygen and serious injuries.
- Keep your cutting area well ventilated or an approved air-supplied respirator.
- Not in locations near degreasing cutting, cleaning or spraying operations. The vapors from some chlorinated solvents decompose phosgene gas when they are exposed to ultraviolet rays.
Pacemakers and hearing aids
--Of cardiac pacemakers and hearing aids, surgery may be influenced by magnetic fields from high currents. Pacemaker and hearing aid wearers should consult a doctor before they close to plasma cutting and gouging operations
Total plasma Security
- The plasma cutting process can be very safe.
- The attention to safety standards and proper installation and operation of the plasma cutting system is no longer a threat than most other welding processes.
ไม่มีความคิดเห็น:
แสดงความคิดเห็น