What is the AC-balance, which is on everyone's lips, that will be so great for TIG welding aluminum? And why should a rat's ass? First, you can now make sure we know what it is AC, Let's face it, we could talk about it, air conditioning, aircraft, or half of the eighties, a rock band. AC refers to alternating current. AC is the direction of flow of electrical current alternates from negative to positive. The power that you get when you plugMixer in the outlet is alternating current. DC or DC shows the current flows in one direction only. Batteries provide direct current or DC. TIG welders are either strictly models DC or AC / DC models are available. The DC models are for steel in order, but you have AC and DC on steel and aluminum welding. Why? Since AC allows molten aluminum and type resolved without overheating of the electrode. The half of the alternating polarityElectricity is supplied by what one is a cathodic etch on aluminum very helpful.
But only reverse polarity welding to overheating of the electrode to a point that it is impractical. Welding on DC negative electrode made of steel will not work well because the aluminum oxide remains, making it impossible to see the puddle. Welding on AC is like a baby bear porridge .. just right! Just enough of the negative electrode to the electrode always keep hot, and the cleaningAction or cathodic etching from the back half of the AC can break through the oxide, you will see the puddle.
But what does the AC do balance? It allows you to adjust the cleaning vs. penetration. Is it really make a difference? In a word: Yes!
What if you are in TIG welding an aluminum tread plate truck box one day and the next day needed to TIG Welding 3 aluminum boat propellers, which had been commissioned in salt water for a year. A material with a polished surface and the other cleanis highly oxidized and probably underground corrosion. A job must be cosmetically appealing, together with a penetration bead, the other is strictly up welding job to be sanded off. The ability to adjust for more or less cleaning or dissemination, is a bit like doing just the right size hammer for the job, instead of one that is too small.
How does it work? This is one way of simplifying, but the lower the polarity and the establishment of moremore cleaning action. The higher the value, the more negative electrode, and a further penetration with a narrower range of cathodic etching marks.
Set it and forget it? If you are not interested in the optimal settings for a particular job, a setting of 7 with weld almost everything pretty well.
ไม่มีความคิดเห็น:
แสดงความคิดเห็น